Engine Hood Courtesy Switch: Installation
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- CONNECT HOOD LOCK CONTROL CABLE ASSEMBLY
- Install the hood lock control cable with the hood lock.
- INSTALL HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)
- Apply MP grease to the sliding surface of the lock.
- Install the hood lock (engine hood courtesy switch) with the 2 bolts and nut.
Torque: 8.0 Nm (82 kgf cm, 71 in. lbf)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).