LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Seat) >> Front Seat Assembly >> Removal

Front Seat Assembly: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE SEAT TRACK OUTER COVER 
    1. Using a screwdriver, detach the claws and remove the 4 covers.

      HINT:

      Tape the screwdriver tip before use.

  3. REMOVE FRONT SEAT ASSEMBLY 
    1. Remove the 4 bolts.
    2. Disconnect the connectors and remove the seat.
      NOTE:
      • When handling the airbag connector, take care not to damage the airbag wire harness.
      • Be careful not to damage the vehicle body.
scientia non olet · About LEMON Manuals