Inspection Procedure
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
When using the intelligent tester, start from 1. When not using the intelligent tester, start from 2.
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER (DOOR LOCK MOTOR)
- Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the door lock motor operates normally.
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
- NG: GO TO NEXT STEP
- INSPECT DOOR LOCK MOTOR
- Inspect front door lock motor (see INSPECTION ).
- Inspect rear door lock motor (see INSPECTION ).
- NG: REPLACE DOOR LOCK MOTOR
- OK: GO TO NEXT STEP
- CHECK WIRE HARNESS (MOTOR - BODY ECU)
- NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE