Rear Lower Control Arm: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE REAR WHEEL
Torque: 131 N*m (,340 kgf*cm, 97 ft.*lbf)
SUPPORT REAR AXLE HOUSING WITH JACK
REMOVE LOWER CONTROL ARM ASSEMBLY
1. Remove the 2 nuts, washers, bolts and lower control arm.
  Torque: 150 N*m (1,530 kgf*cm, 111 ft.*lbf)
  
  HINT:
  
  At the time of installation, please refer to the following items.
  - Replace the 2 used nuts with new ones.
  - After stabilizing the suspension, torque the nuts.
    
    Fig 1: Removing Nuts, Washers, Bolts & Lower Control Arm
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002