Rear Lateral Control Rod: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

SUPPORT REAR AXLE HOUSING WITH JACK
REMOVE REAR LATERAL CONTROL ROD ASSEMBLY
1. Remove the nut, washer, bolt and lateral control rod.
  Torque: 149 N*m (1,520 kgf*cm, 110 ft.*lbf) for bolt
  
  150 N*m (1,530 kgf*cm, 111 ft.*lbf) for nut
  
  HINT:
  
  At the time of installation, please refer to the following items.
  - Replace the 2 used nuts with new ones.
  - After stabilizing the suspension, torque the nuts.
    
    Fig 1: Removing Nut, Washer, Bolt & Lateral Control Rod
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002