Front Lower Suspension Arm: Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT SUSPENSION LOWER ARM ASSEMBLY
1. As shown, flip the ball joint stud back and forth 5 times, before installing the nut.
2. Using a torque wrench, turn the nut continuously one turn per 3 to 5 seconds and take the torque reading on the 5th turn.
  Torque: Standard turning torque
  
  0.29 to 2.94 N*m (3 to 30 kgf*cm, 2.6 to 26 in.*lbf)
  
  Fig 1: Measuring Turning Torque
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002