On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT ROOM LIGHT ASSEMBLY

Measure the continuity of the light.

ROOM LIGHT

Tester Connection	Switch Condition	Specified Condition
1 - 3	Room light switch ON	Continuity
2 - 3	Room light switch DOOR	Continuity
1 - 3 2 - 3	Room light switch OFF	No continuity

If the result is not as specified, replace the light assembly.

Fig 1: Inspecting Room Light Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT REAR ROOM LIGHT ASSEMBLY

Measure the continuity of the light.

REAR ROOM LIGHT (1 OF 2)

Tester Connection	Switch Condition	Specified Condition
2 - Body ground	Room light switch ON	Continuity

If the result is not as specified, replace the light assembly.

Fig 2: Inspecting Rear Room Light Assembly (1 Of 2)

Measure the continuity of the light.

REAR ROOM LIGHT (2 OF 2)

Tester Connection	Switch Condition	Specified Condition
1 - 2	Room light switch DOOR	Continuity

If the result is not as specified, replace the light assembly.

Fig 3: Inspecting Rear Room Light Assembly (2 Of 2)