LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Supplemental Restraint System) >> Occupant Classification Ecu >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT SEAT CUSHION ASSEMBLY (w/Occupant Classification ECU, Occupant Classification Sensor) (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check (See ON-VEHICLE INSPECTION  ).
  2. INSPECT FRONT SEAT CUSHION ASSEMBLY (w/Occupant Classification ECU, Occupant Classification Sensor) (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check (See ON-VEHICLE INSPECTION  ).
    2. Even if the airbag was not deployed, check if there is any damage to the seat position sensor. If there are any defects as mentioned below, replace the seat position sensor with a new one: Cracks, dents or chips on the sensor housing. Cracks or other damage to the connector.
      CAUTION: Be sure to follow the correct removal and installation procedures.
scientia non olet · About LEMON Manuals