LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Supplemental Restraint System) >> FRONT SEAT CUSHION ASSEMBLY (w/Occupant Classification ECU, Occupant Classification Sensor) >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT OCCUPANT CLASSIFICATION ECU (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check (see DTC CHECK/CLEAR  ).
  2. REMOVE OCCUPANT CLASSIFICATION ECU (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check (see DTC CHECK/CLEAR  ).
    2. Even if the airbag was not deployed, check if there is any damage to the occupant classification ECU. If there are any defects as mentioned below, replace the occupant classification ECU with a new one: Cracks, dents or chips on the case. Cracks or other damage to the connector.
      CAUTION: Be sure to follow the correct removal and installation procedures.
scientia non olet · About LEMON Manuals