Curtain Shield Airbag Assembly: Installation
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing (see PRECAUTION
).
- INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
- Install the curtain shield airbag with 8 new bolts.
Torque: 9.8 N*m (100 kgf*cm, 86 in.*lbf)
NOTE: Do not twist the curtain shield airbag assembly when installing it. - Connect the connector.NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
- Install the curtain shield airbag with 8 new bolts.
- INSTALL ROOF HEADLINING ASSEMBLY
- Install the roof headlining assembly (see INSTALLATION ).
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).
- CHECK SRS WARNING LIGHT
- Check the SRS warning light (see DIAGNOSIS SYSTEM ).