Data List/Active Test

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST is the first step of troubleshooting and is one method to shorten labor time.

DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY

Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch ON.

Following the display on the tester screen, read the "DATA LIST".

DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY

Item	Measure Item/Range (Display)	Normal Condition	Diagnostic Note
D SEAT POSITION	Seat position (Driver side)/FORWARD: Seat position is forward BKWARD: Seat position is backward FAIL: Failure detected	FORWARD/BKWARD	-
PASSENGER DETEC	Passenger detection/NG: Date is not determined NONE: No passenger DETECT: Exist passenger FAIL: Failure detected	NONE/DETECT	-
L BUCKLE SW	Buckle switch (Left side)/UNSET: The seat belt is not fastened SET: The seat belt is fastened NG: Data is not determined	UNSET/SET	-
R BUCKLE SW	Buckle switch (Right side)/UNSET: The seat belt is not fastened SET: The seat belt is fastened NG: Data is not determined	UNSET/SET	-
DISPLAY TYPE	Display type identification information/LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger	LR	-
PAST CODES	Number of past trouble codes/Min.: 0, Max.: 255	0	-