Steering Knuckle: Reassembly

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING KNUCKLE BUSH
1. Using SST and a press, press in a new bearing and bushing.
  SST 09950-60010 (09951-00540), 09950-70010 (09951-07100)
2. Apply synthetic oil and lithium soap base chassis grease (NLGI No. 1) to the steering knuckle inner side of the bushing.
  
  Fig 1: Installing Steering Knuckle Bush Using SST & Press
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING KNUCKLE OIL SEAL
1. Using SST and a press, tap in a new oil seal.
  SST 09950-60020 (09951-00910), 09950-70010 (09951-07100)
2. Coat the lip of the oil seal with MP grease.
INSTALL STEERING KNUCKLE ARM
1. Clean the threads of the 2 bolts and steering knuckle with toluene or trichloroethylene.
2. Apply sealant to the bolt threads.
  Sealant:
  
  Part No. 08833-00070, THREE BOND 1324 or equivalent
3. Install the steering knuckle arm with the 2 bolts.
  Torque: 147 N*m (1,500 kgf*cm, 108 ft.*lbf)
  
  Fig 2: Installing Steering Knuckle Oil Seal Using SST & Press
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002