POWER TRANSISTOR (W/ Rear Cooler): Removal
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE REAR DOOR SCUFF PLATE RH
- REMOVE REAR FLOOR MAT SUPPORT PLATE
- REMOVE QUARTER TRIM PANEL RH
- REMOVE POWER TRANSISTOR
- Disconnect the connector.
- Remove the 2 screws and the power transistor.