Compressor And Magnetic Clutch: Disassembly

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE PRESSURE PLATE
1. Using SST and a socket wrench, remove the shaft bolt.
  SST 07112-76060
  
  Torque: 13.2 N*m (135 kgf*cm, 9 ft.*lbf)
  
  Fig 1: Removing Shaft Bolt Using SST & Socket Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install SST on the pressure plate.
  SST 07112-66040
  
  Fig 2: Installing SST On Pressure Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and socket wrench, remove the pressure plate.
  SST 07112-66040, 07112-76060
  
  Fig 3: Removing Pressure Plate Using SST & Socket Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the shims from the pressure plate.
  
  Fig 4: Removing Shims From Pressure Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ROTOR
1. Using SST, remove the snap ring.
  SST 95994-10020
  
  Fig 5: Removing Snap Ring Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. At the time of reassembly.
    NOTE: The snap ring should be installed so that beveled side facing up.
    
    Fig 6: Inspecting Snap Ring Position
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a plastic-faced hammer, tap the rotor off the shaft.
  NOTE: Be careful not to damage the pulley when tapping on the rotor.
  
  Fig 7: Tapping Rotor Off Shaft Using Hammer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STATOR COIL
1. Disconnect the stator lead wire from the compressor housing.
  
  Fig 8: Disconnecting Stator Lead Wire From Compressor Housing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, remove the snap ring.
  SST 95994-10020
  
  Fig 9: Removing Snap Ring Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. At the time of reassembly.
    NOTE: The snap ring should be installed so that its beveled side facing up.
    
    Fig 10: Inspecting Snap Ring Position
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the stator.
  
  Fig 11: Removing Stator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002