Blower Unit: Disassembly

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE AIR INLET SERVOMOTOR
1. Remove the 3 screws and air inlet servomotor.
  
  Fig 1: Removing Air Inlet Servomotor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER MOTOR CONTROL RELAY
1. Disconnect the connector.
2. Remove the screw and blower motor control relay.
  
  Fig 2: Removing Blower Motor Control Relay Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER MOTOR
1. Disconnect the connector.
2. Remove the 3 screws and blower motor.
REMOVE WIRE HARNESS
1. Remove the screw and wire harness.
  
  Fig 3: Removing Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002