Air Mix Control Servo Motor: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE AIR MIX SERVO MOTOR
1. Disconnect the connector.
2. Remove the 3 screws and air mix servo motor.
  
  Fig 1: Removing Air Mix Servo Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002