Data List/Active Test
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- DATA LIST
HINT:
According to the DATA LIST displayed by the intelligent tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one of the method to shorten the labor time.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON.
- According to the display on the tester, read the "DATA LIST".DATA LIST
Item Measurement Item/Display (Range) Normal Condition A/C SIG A/C SW Status/ON or OFF - A/C SW Push: ON
- A/C SW Release: OFF
A/C MAG CLUTCH A/C magnet clutch status/ON or OFF - A/C SW Push: ON
- A/C SW Release: OFF
- ACTIVE TEST
HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, VSV, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as a first step of troubleshooting is one of the method to shorten the labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.