Vane Pump: Replacement

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When using a vise, do not overtighten it.

REPLACE OIL SEAL
1. Using a screwdriver with vinyl tape wound around its tip, remove the oil seal.
  NOTE: Be careful not to damage the front housing.
  
  Fig 1: Removing Oil Seal Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat a new oil seal lip with power steering fluid.
3. Using SST, press in the oil seal.
  SST 09950-60010 (09951-00280), 09950-70010 (09951-07100)
  
  NOTE: Make sure to install the oil seal facing the correct direction.
  
  Fig 2: Pressing In Oil Seal Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002