Front Extension Housing: Disassembly

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE DRIVE CLUTCH HUB
1. Using a snap ring expander, remove the snap ring.
2. Using SST, remove the drive clutch hub.
  SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04021, 09957-04010, 09958-04011)
  
  Fig 1: Removing Drive Clutch Hub Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT OUTPUT SHAFT
1. Using a plastic-faced hammer, tap out the output shaft.
  
  Fig 2: Tapping Out Output Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE DUST DEFLECTOR
1. Using SST, remove the dust deflector from the output shaft.
  SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)
  
  Fig 3: Removing Dust Deflector From Output Shaft Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver and a hammer, tap the dust deflector and remove it from the extension housing.
  
  Fig 4: Tapping Dust Deflector Using Screwdriver & Hammer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE OIL SEAL
1. Using a screwdriver, pry out the oil seal from the front extension housing.
  
  Fig 5: Prying Out Oil Seal From Front Extension Housing Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BALL BEARING
1. Using a screwdriver, remove the snap ring.
  
  Fig 6: Removing Snap Ring Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, press out the ball bearing.
  SST 09316-60011 (09316-00011, 09316-00071)
  
  Fig 7: Pressing Out Ball Bearing Using SST & Press
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002