Rear Propeller Shaft Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR PROPELLER SHAFT
1. Align the matchmarks on the propeller shaft flange and transfer flange.
2. Connect the propeller shaft with the 4 washers and 4 nuts.
  Torque: 106 N*m (1,080 kgf*cm, 78 ft.*lbf)
  
  Fig 1: Aligning Matchmarks On Propeller Shaft Flange & Transfer Flange
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the matchmarks on the propeller shaft flange and differential flange.
4. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.
  Torque: 106 N*m (1,080 kgf*cm, 78 ft.*lbf)
  
  Fig 2: Aligning Matchmarks On Propeller Shaft Flange & Differential Flange
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002