Front Propeller Shaft Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT PROPELLER SHAFT ASSEMBLY
1. Align the matchmarks on the yoke and differential flange.
2. Connect the propeller shaft with the 4 washers and 4 nuts.
  Torque: 80 N*m (820 kgf*cm, 59 ft.*lbf)
  
  Fig 1: Aligning Matchmarks On Yoke & Differential Flange
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the matchmarks on the yoke and transfer flange.
4. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.
  Torque: 80 N*m (820 kgf*cm, 59 ft.*lbf)
  
  Fig 2: Aligning Matchmarks On Yoke & Transfer Flange
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002