Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

When using the intelligent tester, start from 1. When not using the intelligent tester, start from 2.

PERFORM ACTIVE TEST BY INTELLIGENT TESTER (PARKING BRAKE SWITCH)
1. Connect the intelligent tester to the DLC3.
2. Check that the parking brake switch operate in DATA LIST (see DATA LIST / ACTIVE TEST ).
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE

NG: GO TO NEXT STEP
INSPECT PARKING BRAKE SWITCH ASSEMBLY
NG: REPLACE PARKING BRAKE SWITCH ASSEMBLY

OK: GO TO NEXT STEP
CHECK WIRE HARNESS (PARKING BRAKE SWITCH - BODY ECU)
NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE