Ignition Coil: Removal
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
- REMOVE INTAKE AIR CONNECTOR PIPE (See REMOVAL )
- DISCONNECT ENGINE WIRE
- Disconnect the 2 engine wire clamps from the cylinder head cover LH side.
- REMOVE IGNITION COIL ASSEMBLY
- Disconnect the connector.
- Remove the bolt and ignition coil.