LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Parking Brake) >> Parking Brake Lever >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK PARKING BRAKE LEVER TRAVEL 
    1. Pull the lever upward with a force of approximately 196 N (20 kgf, 44 lbf) and count the number of clicks.

      OK: 4 to 6 clicks 

  2. ADJUST PARKING BRAKE 

    HINT:

    Before adjusting the parking brake, make sure that the paring brake shoe clearance has been adjustment (see REASSEMBLY  ).

    1. Loosen the lock nut and turn the turn buckle until the lever travel is correct.
    2. Tighten the lock nut.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      Fig 1: Loosening Lock Nut & Turning Turn Buckle
      G04437782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002