Front Bumper: Installation

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BUMPER REINFORCEMENT SUBASSEMBLY
1. Install the reinforcement with the 8 bolts.
  
  Fig 1: Installing Reinforcement With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 58 N*m (590 kgf*cm, 43 ft.*lbf)
INSTALL FRONT BUMPER ENERGY ABSORBER
INSTALL FOG LIGHT ASSEMBLY LH
1. Install the fog light with the nut.
  Torque: 5.0 N*m (50 kgf*cm, 43 in.*lbf)
INSTALL FOG LIGHT ASSEMBLY RH
1. Install the fog light with the nut.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL FRONT BUMPER COVER
1. Connect the 2 fog light connectors.
2. Install the bumper cover with the 3 clips, 2 screws and 4 bolts.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) for screw
  
  8.5 N*m (87 kgf*cm, 76 in.*lbf) for bolt
INSTALL RADIATOR GRILLE (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  
  Fig 2: Installing & Fog Light With Nut LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002