Steering Pad: Installation
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing (see PRECAUTION
).
- INSTALL STEERING PAD ASSEMBLY
- Support the steering pad with one hand as shown in Figure .
- Connect the 2 airbag connectors.NOTE: When handling the airbag connector, do not damage the airbag wire harness.
- Connect the horn connector.
- Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
- Using a T30 "torx" socket, install the 2 screws.
Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
- Install the steering wheel lower covers.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- INSPECT STEERING PAD ASSEMBLY
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).
- CHECK SRS WARNING LIGHT
- Check the SRS warning light (see DIAGNOSIS SYSTEM ).