LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Supplemental Restraint System) >> Side Airbag Sensor >> Removal

Side Airbag Sensor: Removal

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing (see PRECAUTION  ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE REAR DOOR SCUFF PLATE 
  3. REMOVE FRONT DOOR SCUFF PLATE 
  4. REMOVE SEAT BELT OUTER ANCHOR COVER 
  5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP 
  6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP 
  7. REMOVE CENTER PILLAR GARNISH LOWER 
  8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
  9. REMOVE SIDE AIRBAG SENSOR 
    1. Remove the 2 bolts and sensor.
    2. Disconnect the connector.
      Fig 1: Removing Bolts & Sensor
      G04438351Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals