Seat Position Sensor: Removal
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing (see PRECAUTION
).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE FRONT SEAT ASSEMBLY
- Remove the front seat assembly (see REMOVAL ).
- REMOVE SEAT POSITION SENSOR
- Disconnect the connector.
- Remove the bolt and seat position sensor.