Data List/Active Test

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

READ DATA LIST FOR OCCUPANT CLASSIFICATION ECU

Connect the intelligent tester (with CAN VIM) to the DLC3.
Turn the ignition switch ON.

Following the display on the tester screen, read the DATA LIST.

HINT:

The Specified Condition for Zero Point Calibration in ITEM NORMAL CONDITION TABLE must be satisfied when the zero point calibration is performed.

Occupant classification ECU

Fig 1: Connecting Intelligent Tester To DLC3

ITEM NORMAL CONDITION TABLE

Item	Measurement Item / Range (Display)	Normal Condition	Specified Condition for Zero Point Calibration	Diagnostic Note
PASSENGER CLASS	Passenger classification / NG / AF05 / AM50 / CHILD / OFF	NG: Data is not determined AM50: Adult is seated and seat is in rear position AF05: Adult is seated and seat is in front position CHILD: Child is seated OFF: Vacant	OFF	-
P BUCKLE SW	Buckle switch (Passenger side) / NG / UNSET / SET	SET: Passenger side seat belt is fastened UNSET: Passenger side seat belt is unfastened NG: Data is not determined	UNSET	-
SEAT POSITION	Seat position / NG / ON / OFF	ON: Seat is in front position OFF: Seat is in rear position NG: Data is not determined	ON / OFF	-
RELATIVE PRESS	Pressure sensor output / Min.: 0 Max.: 255	0 to 210	0 to 2	-
FILTERED PRESS	Filtered pressure sensor output / Min.: 0 Max.: 255	38 to 240	38 to 75	If value outside range of Specified Condition for Zero Point Calibration, check for objects placed on seat cushion and that seat cushion fitted correctly.
THERMISTOR TEMP	Thermistor temperature output / Min.: -40°C (-40°F) Max.: 90°C (194°F)	-40 to 85°C (-40 to 185°F)	3 to 40°C (36 to 104°F)	If value outside range of Specified Condition for Zero Point Calibration, adjust temperature to proper range by using air conditioner, etc.
WEIGHT THRESH	Weight threshold / Min.: 0 Max.: 255	36 to 67 (reference value)	36 to 67 (reference value)	-
FILTERED TENSION	Filtered belt tension output / Min.: 0 Max.: 255	39 to 229	39 to 64 (no load)	-
EMPTY THRESH	Empty threshold value from seat factory / Min.: 0 Max.: 255	38 to 75	38 to 75	-
ALLOW THRESH	Threshold value for adult passenger or not from seat factory / Min.: 0 Max.: 255	43 to 64 (reference value)	43 to 64 (reference value)	-
#PRESENT CODES	Number of present trouble codes / Min.: 0 Max.: 255	0	0	-
#PAST CODES	Number of past trouble codes / Min.: 0 Max.: 255	0	0	-