DTC B1774, B1775: Pressure Sensor Circuit Malfunction: Pressure Sensor Power Source Circuit Malfunction: Description

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

The pressure sensor circuit consists of the occupant classification ECU and the occupant classification sensor.

The occupant classification sensor sends the pressure signal to the occupant classification ECU to control the occupant classification system.

DTCs B1774 and B1775 are recorded when a malfunction is detected in the pressure sensor circuit.

DIAGNOSTIC TROUBLE CODE TABLE

DTC No.	DTC Detection Condition	Trouble Area
B1774 B1775	When one of following conditions is met: Occupant classification ECU receives line short circuit signal, open circuit signal, short circuit to ground signal or short circuit to B+ signal in pressure sensor circuit for 2 seconds. Occupant classification sensor malfunction Occupant classification ECU malfunction	No. 1 seat wire Front seat cushion assembly (Occupant classification sensor) Occupant classification ECU

NOTE: Replace the occupant classification ECU, occupant classification sensor, seat cushion cover pad, seat cushion cover and seat cushion seat heater as a 5 part set (see supply set part no.).

HINT:

When DTC B1650/32 is detected as a result of troubleshooting the supplemental restraint system, check the DTCs stored in the occupant classification ECU, and perform troubleshooting for those DTCs first.
Use the intelligent tester to check for DTCs of the occupant classification ECU, otherwise the DTC cannot be read.