Error in Past When Identifying Transmitter: Description

HINT:

• Refer to ERROR IN PRESENT WHILE IDENTIFYING TRANSMITTER  if the DTC is currently output. Refer to ERROR IN PAST WHEN IDENTIFYING TRANSMITTER  if a previously output DTC is not output now. Even when DTCs C2165/65 to C2169/69 are output both as present and past codes, refer to ERROR IN PAST WHEN IDENTIFYING TRANSMITTER .
• DTCs relevant to the transmitters correspond to each transmitter ID. It is impossible to identify which tire is malfunctioning according to each transmitter ID. Therefore the following procedures must be followed to confirm the ID No. and tire location.
• The following are the procedures to identify which wheel's transmitter ID1 is resulting from when assuming that either of the DTCs C2141/41 (Transmitter ID1 error) or C2165/65 (Abnormal temperature inside ID1 tire) is detected. Identify the corresponding transmitter using the same procedures when DTCs C2142/42 to C2145/45, and C2166/66 to C2169/69 are detected.

1. SET PRESSURE OF ALL TIRES TO SPECIFIED VALUE 

   Standard pressure 

   TIRE PRESSURE SPECIFICATIONS
   
   

   Front		Rear		Spare
   200 kPa (2.0 kgf/cm2 , 29 psi)	Trailer Towing	220 kPa (2.2 kgf/cm2 , 32 psi)	Trailer Towing	220 kPa (2.2 kgf/cm2 , 32 psi)	Trailer Towing
   	220 kPa (2.2 kgf/cm2 , 32 psi)		240 kPa (2.4 kgf/cm2 , 35 psi)		240 kPa (2.4 kgf/cm2 , 35 psi)

2. RAPIDLY REDUCE PRESSURE OF FRONT RIGHT WHEEL 
   1. Rapidly reduce the pressure of the front right wheel to 120 kPa (1.2 kgf/cm² , 17 psi).
3. USING INTELLIGENT TESTER, CHECK ID1 TIRE PRESSURE DATA 
   TIRE PRESSURE DATA
   
   

   Item	Measurement item/Range (Display)	Normal Condition	Diagnostic Note
   TIREPRESS1	ID1 tire inflation pressure / min.: 0 kPa (0 kgf/cm2 , 0 psi), max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)	Actual tire inflation pressure	-

4. CHECK ID1 TIRE PRESSURE 
   1. Check that ID1 tire pressure is 120 kPa (1.2 kgf/cm² , 17 psi).

      OK: 

      ID1 tire pressure is 120 kPa (1.2 kgf/cm ²  , 17 psi). 

   OK: THE ID1 IS FOR FRONT RIGHT WHEEL TRANSMITTER 

   NG: GO TO NEXT STEP 

5. RAPIDLY REDUCE PRESSURE OF FRONT LEFT WHEEL 
   1. Rapidly reduce the pressure of the front left wheel to 120 kPa (1.2 kgf/cm² , 17 psi).
6. USING INTELLIGENT TESTER, CHECK ID1 PRESSURE DATA 
   TIRE PRESSURE DATA
   
   

   Item	Measurement item/Range (Display)	Normal Condition	Diagnostic Note
   TIREPRESS1	ID1 tire inflation pressure / min.: 0 kPa (0 kgf/cm2 , 0 psi), max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)	Actual tire inflation pressure	-

7. CHECK ID1 TIRE PRESSURE 
   1. Check that ID1 tire pressure is 120 kPa (1.2 kgf/cm² , 17 psi).

      OK: 

      ID1 tire pressure is 120 kPa (1.2 kgf/cm ²  , 17 psi). 

   OK: THE ID1 IS FOR FRONT LEFT WHEEL TRANSMITTER 

   NG: GO TO NEXT STEP 

8. RAPIDLY REDUCE PRESSURE OF REAR RIGHT WHEEL 
   1. Rapidly reduce the pressure of the rear right wheel to 120 kPa (1.2 kgf/cm² , 17 psi).
9. USING INTELLIGENT TESTER, CHECK ID1 TIRE PRESSURE DATA 
   TIRE PRESSURE DATA
   
   

   Item	Measurement item/Range (Display)	Normal Condition	Diagnostic Note
   TIREPRESS1	ID1 tire inflation pressure / min.: 0 kPa (0 kgf/cm2 , 0 psi), max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)	Actual tire inflation pressure	-

10. CHECK ID1 TIRE PRESSURE 
    1. Check that ID1 tire pressure is 120 kPa (1.2 kgf/cm² , 17 psi).

       OK: 

       ID1 tire pressure is 120 kPa (1.2 kgf/cm ²  , 17 psi). 

    OK: THE ID1 IS FOR REAR RIGHT WHEEL TRANSMITTER 

    NG: GO TO NEXT STEP 

11. RAPIDLY REDUCE PRESSURE OF REAR LEFT WHEEL 
    1. Rapidly reduce the pressure of the rear left wheel to 120 kPa (1.2 kgf/cm² , 17 psi).
12. USING INTELLIGENT TESTER, CHECK THE ID1 TIRE PRESSURE DATA 
    TIRE PRESSURE DATA
    
    

    Item	Measurement item/Range (Display)	Normal Condition	Diagnostic Note
    TIREPRESS1	ID1 tire inflation pressure/min.: 0 kPa (0 kgf/cm2 , 0 psi), max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)	Actual tire inflation pressure	-

13. CHECK ID1 TIRE PRESSURE 
    1. Check that ID1 tire pressure is 120 kPa (1.2 kgf/cm² , 17 psi).

       OK: 

       ID1 tire pressure is 120 kPa (1.2 kgf/cm ²  , 17 psi). 

    OK: THE ID1 IS FOR REAR LEFT WHEEL TRANSMITTER 

    NG: THE ID1 IS FOR SPARE TIRE TRANSMITTER