LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Tire & Wheel) >> Tire Pressure Warning System >> Data List/Active Test

Data List/Active Test

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 
    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Following the display on the intelligent tester, read the "DATA LIST".

      Tire Pressure Monitor ECU 

      TIRE PRESSURE MONITOR ECU DATA LIST REFERENCE

      Item Measurement item/Range (Display) Normal Condition Diagnostic Note
      MODE STATUS Tire pressure warning system mode/NORMAL or REG 2nd or REG M or TEST NORMAL: Normal mode TEST: Test mode
      TEST: Test mode      		 -
      MAIN TIRE Number of main tire IDs to be registered / 0 or 1 or 2 or 3 or 4 or 5 0 to 5 should be displayed -
      2ND TIRE Number of 2ND tire IDs to be registered / 0 to 1 or 2 or 3 or 4 or 5 0 to 5 should be displayed -
      SELECT SW Select switch / Main, 2nd MAIN: Not pressing
      2nd: Pressing      		 -
      INITIAL SW Initialization switch / ON, OFF ON: Switch on
      OFF: Switch off      		 -
      VEHICLE SPEED Vehicle speed reading /
      min.: 0 km/h (0 mph),
      max.: 255 km/h (158 mph)      		 Actual vehicle speed Speed indicated on the combination meter
      REGIT ID1" CODE Registered ID1" code / min.: 0, max.: FFFFFFF The ID No. registered in the transmitter ID1 is displayed -
      REGIT ID2" CODE Registered ID2" code / min.: 0, max.: FFFFFFF The ID No. registered in the transmitter ID2 is displayed -
      REGIT ID3" CODE Registered ID3" code / min.: 0, max.: FFFFFFF The ID No. registered in the transmitter ID3 is displayed -
      REGIT ID4" CODE Registered ID4" code / min.: 0, max.: FFFFFFF The ID No. registered in the transmitter ID4 is displayed -
      REGIT ID5" CODE Registered ID5" code / min.: 0, max.: FFFFFFF The ID No. registered in the transmitter ID5 is displayed -
      TRANS STATUS ID code transmission status / FINISH or NOW FINISH or NOW -
      TRANS PLACE ID code transmission place / MAIN or 2nd MAIN or 2nd -
      TIREPRESS1 ID1 tire inflation pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi)
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Actual tire inflation pressure -
      TIREPRESS2 ID2 tire inflation pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi)
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Actual tire inflation pressure -
      TIREPRESS3 ID3 tire inflation pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi)
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Actual tire inflation pressure -
      TIREPRESS4 ID4 tire inflation pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi)
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Actual tire inflation pressure -
      TIREPRESS5 ID5 tire inflation pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi)
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Actual tire inflation pressure -
      TIRE TEMP1 ID1 temperature in tire /
      min.: -40°C (-40°F)
      max.: 215°C (419°F)      		 Actual tire temperature -
      TIRE TEMP2 ID2 temperature in tire /
      min.: -40°C (-40°F)
      max.: 215°C (419°F)      		 Actual tire temperature -
      TIRE TEMP3 ID3 temperature in tire /
      min.: -40°C (-40°F)
      max.: 215°C (419°F)      		 Actual tire temperature -
      TIRE TEMP4 ID4 temperature in tire /
      min.: -40°C (-40°F)
      max.: 215°C (419°F)      		 Actual tire temperature -
      TIRE TEMP5 ID5 temperature in tire /
      min.: -40°C (-40°F)
      max.: 215°C (419°F)      		 Actual tire temperature -
      BATT VOLT1 ID1 battery voltage / OVER or LESS OVER -
      BATT VOLT2 ID2 battery voltage / OVER or LESS OVER -
      BATT VOLT3 ID3 battery voltage / OVER or LESS OVER -
      BATT VOLT4 ID4 battery voltage / OVER or LESS OVER -
      BATT VOLT5 ID5 battery voltage / OVER or LESS OVER -
      SELECT SW INFO Select switch setting information / WITH or WITHOUT WITH or WITHOUT -
      INITIAL SW INFO Initialization switch setting information / WITH or WITHOUT WITH or WITHOUT -
      INIT THRESHOLD1 ID1 initial threshold of low-pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi),
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Tire pressure after initialization -
      INIT THRESHOLD2 ID2 initial threshold of low-pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi),
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Tire pressure after initialization -
      INIT THRESHOLD3 ID3 initial threshold of low-pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi),
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Tire pressure after initialization -
      INIT THRESHOLD4 ID4 initial threshold of low-pressure / Tire pressure after initialization -
      INIT THRESHOLD5 ID5 initial threshold of low-pressure /
      min.: 0 kPa (0 kgf/cm2 , 0 psi),
      max.: 637.5 kPa (6.48 kgf/cm2 , 92.2 psi)      		 Tire pressure after initialization -
      # CODES Number of DTC recorded/
      min.: 0
      max.: 255      		 Min.: 0
      Max.: -      		 -
scientia non olet · About LEMON Manuals