Tire Pressure Warning Receiver: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH 
   1. Remove the lower frame bracket garnish (see REMOVAL ).
3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY 
   1. Remove the regulator switch (see REMOVAL ).
4. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL 
   1. Remove the inside handle bezel (see REMOVAL ).
5. REMOVE NO. 1 DOOR INSIDE HANDLE BEZEL 
   1. Remove the inside handle bezel (see REMOVAL ).
6. REMOVE FRONT DOOR COURTESY LIGHT 
   1. Remove the courtesy light (see REMOVAL ).
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY 
   1. Remove the trim board (see REMOVAL ).
8. REMOVE TWEETER SPEAKER 
   1. Remove the tweeter speaker (see REMOVAL ).
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY 
   1. With Tire pressure monitor receiver:
      1. Remove the rear view mirror (see REMOVAL ).