LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Tire & Wheel) >> Tire Pressure Warning Receiver >> Installation

Tire Pressure Warning Receiver: Installation

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY 
    1. Install the rear view mirror (see DISASSEMBLY ).
  2. INSTALL TWEETER SPEAKER 
    1. Install the tweeter speaker (see DISASSEMBLY ).
  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY 
    1. Install the trim board (see DISASSEMBLY ).
  4. INSTALL FRONT DOOR COURTESY LIGHT ASSEMBLY 
    1. Install the courtesy light (see DISASSEMBLY ).
  5. INSTALL NO. 1 DOOR INSIDE HANDLE BEZEL 
    1. Install the inside handle bezel (see DISASSEMBLY ).
  6. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL 
    1. Install the inside handle bezel (see DISASSEMBLY )
  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY 
    1. Install the regulator switch (see DISASSEMBLY ).
  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH 
    1. Install the lower frame bracket garnish (see DISASSEMBLY ).
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals