1NZ-FE Engine Mechanical: Equipment
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
EQUIPMENT CHART - 1NZ-FE ENGINE MECHANICAL
| Alignment tester |
| Angle gauge |
| Bar |
| Caliper gauge |
| CO/HC meter |
| Compression gauge |
| Connecting rod aligner |
| Cylinder gauge |
| Dial indicator |
| Feeler gauge |
| Heater |
| Micrometer |
| Piston ring compressor |
| Piston ring expander |
| Plastic hammer |
| Plastigage |
| Straight edge |
| Reamer |
| Slide caliper |
| Tachometer |
| Timing light |
| Torque wrench |
| Valve seat cutter |
| V-block |
| Vernier caliper |
| Wooden block |
| Thermometer |
| Spring tester |
| Engine lifter |
| Engine sling device |
| Chain block |
| Wire brush |
| Chisel |
| Hammer |
| Radiator cap tester |