LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Meter) >> METER / GAUGE SYSTEM (for Sedan) >> Driver Side Seat Belt Warning Light does not Operate >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK SUPPLEMENTAL RESTRAINT SYSTEM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON and turn the tester ON.
    3. Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.

      Result 

      RESULT CHART

      Result Proceed to
      No SRS DTCs are output A
      SRS DTCs are output B

    B:  GO TO SUPPLEMENTAL RESTRAINT SYSTEM

    A: Go to Next Step 

  2. PERFORM ACTIVE TEST BY TECHSTREAM (D-BELT REMIND) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON and turn the tester ON.
    3. Enter the following menus: Body Electrical / Combination Meter / Active Test.

      Body Electrical / Combination Meter / Active Test: 

      BODY ELECTRICAL / COMBINATION METER / ACTIVE TEST

      Tester Display Test Part Control Range
      Driver Side Seat Belt Front driver seat belt warning light / OFF or ON Confirm that vehicle is stopped and engine is idling

      OK: 

      Front driver seat belt warning light comes on. 

    OK: REPLACE MAIN BODY ECU 

    NG: REPLACE COMBINATION METER ASSEMBLY 

scientia non olet · About LEMON Manuals