LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Meter) >> METER / GAUGE SYSTEM (for Hatchback) >> Initialization

METER / GAUGE SYSTEM (for Hatchback): Initialization

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. OIL MAINTENANCE INDICATOR RESETTING PROCEDURE (U.S.A. only) 
    OIL MAINTENANCE INDICATOR RESETTING PROCEDURE (U.S.A. ONLY)

    Oil Maintenance Indicator Condition Specified State
    Blinks Vehicle has run 4,500 miles since previous setting Indicator blinks for 15 seconds after ignition switch is turned ON (including 3 seconds for a valve check)
    Illuminates Vehicle has run 5,000 miles since previous setting Indicator illuminates after ignition switch is turned ON.
    1. Set the window display located inside the combination meter to the Trip A indication.
    2. Turn the ignition switch OFF.
    3. While pressing the ODO/TRIP display change switch (reset switch) (for at least 5 seconds), turn the ignition switch ON.
    4. When the reset procedure has been completed successfully, the MAINT REQD indicator light turns off and the ODO/TRIP meter indicates 0 (zero) and then returns to its regular display.

      HINT:

      If the reset fails, the MAINT REQD indicator light remains illuminated. Perform the procedure again.

scientia non olet · About LEMON Manuals