Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- PERFORM INITIALIZATION (TORQUE SENSOR ZERO POINT)
- PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
- CONFIRM DTC
- Check for DTCs (See DTC CHECK / CLEAR
).
Result
RESULT CHARTDTC still output even after performing torque sensor zero point calibration 3 times. A DTC still output even after performing torque sensor zero point calibration once or twice. B Normal system code output. C HINT:
The steering column assembly must be replaced if C1516/16 is still output even after the torque sensor zero point calibration is performed 3 times.
B: Go to step 1
C: END
A: REPLACE STEERING COLUMN ASSEMBLY
- Check for DTCs (See DTC CHECK / CLEAR
).