WASHER NOZZLE (for Hatchback): Adjustment

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT WIPER ARM HEAD CAP (See REMOVAL )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See REMOVAL )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See REMOVAL )
REMOVE HOOD TO COWL TOP SEAL (See REMOVAL )
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See REMOVAL )
REMOVE COWL TOP VENTILATOR LOUVER LH (See REMOVAL )
REMOVE WASHER NOZZLE
1. Disconnect the washer hose.
2. Disengage the 2 claws and remove the front washer nozzle.
  NOTE: Do not reuse the washer nozzle.
  
  Fig 1: Identifying Front Washer Nozzle Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

ADJUST WASHER NOZZLE

Select a washer nozzle from the table so as to make the washer fluid hit within the specified area.

Available Washer Nozzle

DISCRIMINATION NUMBER AND WASHER FLUID INJECTION ANGLE

Part Number	Discrimination Number	Washer Fluid Injection Angle
85381-52250	12	0°
85381-52280	13	+ 1°
85381-52290	11	-1°
85381-52300	14	+ 2°
85381-52310	10	-2°

Fig 2: Identifying Discrimination Number

INSTALL COWL TOP VENTILATOR LOUVER LH (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL HOOD TO COWL TOP SEAL (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT WIPER ARM HEAD CAP (See INSTALLATION )