On-Vehicle Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT WASHER LEVEL WARNING SWITCH
- Check the operation of the washer level warning switch.
- Fill the washer jar with washer fluid.
HINT:
The operation should be performed with the washer level warning switch installed on the washer jar.
- Connect the positive (+) battery lead to terminal 1 of the washer level warning switch, and the negative (-) battery lead to terminal 2.
- Check the resistance.
HINT:
Pull out the washer hose connected to the washer motor. Perform the inspection while draining the washer fluid off.
Standard Resistance
AMOUNT OF REMAINING WASHER FLUID AND SPECIFIED CONDITIONAmount of remaining washer fluid Specified Condition 600 to 800 ml or more 10 kΩ or higher 600 to 800 ml or less Below Ω If the result is not as specified, replace the washer jar.
- Fill the washer jar with washer fluid.
- Check the operation of the washer level warning switch.