REAR WIPER RUBBER (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE REAR WIPER BLADE ASSEMBLY
1. Raise the rear wiper blade to the position shown in the illustration, where the meshing of the claw disengages making a clicking sound.
  NOTE: Do not break the claw.
  
  Fig 1: Identifying Rear Wiper Blade
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull the rear wiper blade straight away from the wiper arm toward the left side of the vehicle.
  NOTE: Do not bend the rear wiper arm with the rear wiper blade removed, as the arm tip could damage the windshield surface.
  
  Fig 2: Identifying Rear Wiper Blade
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR WIPER RUBBER
1. Pull the end of the wiper rubber protruding from the blade stopper as shown in the illustration.
  NOTE: Do not pull out the wiper rubber forcibly.
  Otherwise, the backing plates will be deformed or the blade claw will be damaged.
  
  HINT:
  
  Pushing the rubber from the end toward the middle of the rear wiper blade allows it to be removed more easily.
  
  Fig 3: Identifying Rear Wiper Rubber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 wiper rubber backing plates from the wiper rubber.
Fig 4: Identifying Wiper Rubber Backing Plates Onto Wiper Rubber
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002