REAR WIPER RUBBER (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR WIPER RUBBER
1. Install the 2 wiper rubber backing plates onto the wiper rubber.
  NOTE: Install the backing plates facing the correct direction.
2. Insert the rear wiper rubber from the claw position of the middle of the rear wiper blade to the end.
  
  Fig 1: Identifying Rear Wiper Rubber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. After passing the rear wiper rubber through the rear end side claw, allow it to protrude from the rear end stopper and slide it through the front tip side claw.
  
  Fig 2: Identifying Rear Wiper Rubber Through Rear End Side Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER BLADE ASSEMBLY
1. Engage the claw and install the wiper blade.
  
  Fig 3: Identifying Rear Wiper Blade Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002