LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 240 (Wiper System & Washer System) >> FRONT WIPER MOTOR (for Sedan) >> Removal

FRONT WIPER MOTOR (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WIPER ARM HEAD CAP 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.
      Fig 1: Removing Front Wiper Arm Head Cap
      G04833018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH 
    1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
    2. Fig 2: Identifying Front Wiper Arm And Blade Assembly Nut
      G04833019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the nut and front wiper arm.
  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH 

    HINT:

    Use the same procedure as for the LH side.

  5. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY LH 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the cowl side ventilator sub-assembly LH.
  6. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY RH 

    HINT:

    Use the same procedure as for the LH side.

    Fig 3: Identifying Cowl Side Ventilator Sub-Assembly
    G04833020Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY 
    1. Disengage the 3 clips, the 4 claws and the 8 hooks.
    2. Fig 4: Identifying Cowl Top Ventilator Louver Sub-Assembly Clips, Claws And Hooks
      G04833021Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the cowl top ventilator louver sub-assembly.
    4. Disconnect the washer hoses.
    5. Disengage the 5 hooks.
      Fig 5: Identifying Cowl Top Ventilator Louver Sub-Assembly Hooks
      G04833022Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FRONT WIPER MOTOR AND LINK 
    1. Remove the 2 bolts.
    2. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.
      Fig 6: Identifying Front Wiper Motor And Link Bolts
      G04833023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT WIPER MOTOR 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.
      Fig 7: Identifying Front Wiper Motor
      G04833024Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and the front wiper motor.
      Fig 8: Identifying Front Wiper Motor Bolts
      G04833025Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002