DTC C1210/36: Zero Point Calibration of Yaw Rate Sensor Undone: Description
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTION CONDITION AND TROUBLE AREA REFERENCE
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1210/36 |
When either of the following 1 and 2 is detected:
- After battery terminal was connected, when the shift lever was moved to other than P position within 15 sec. soon after ECU terminal IG1 becomes ON for the first time.
- When the yaw rate sensor zero point recorded in ECU is deleted.
|
- Yaw rate sensor
- Yaw rate sensor circuit
- PNP switch circuit (P position)
|