LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Engine Control System (1NZ-FE)) >> SFI System >> DTC P0011 Camshaft Position "A" - Timing Over-Advanced or System Performance (Bank 1); DTC P0012 Camshaft Position "A" - Timing Over-Retarded (Bank 1) >> Typical Malfunction Thresholds

Typical Malfunction Thresholds

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL MALFUNCTION THRESHOLDS CHART

All of following conditions met -
Deviation of valve timing More than 5°CA (Crankshaft Angle)
Valve timing No change

If the difference between the target and actual camshaft timings is greater than the specified value, the ECM operates the VVT actuator.

Then, the ECM monitor the camshaft timing change for 10 seconds.

scientia non olet · About LEMON Manuals