Crankshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
2. Install the crankshaft position sensor with the bolt.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
  
  NOTE: Do not twist the O-ring.
  
  Fig 1: Identifying Crankshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the crankshaft position sensor connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK FOR ENGINE OIL LEAKAGE
INSTALL ENGINE UNDER COVER RH