Camshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CAMSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring on the camshaft position sensor.
2. Install the camshaft position sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE: Do not twist the O-ring.
  
  Fig 1: Identifying Camshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the camshaft position sensor connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK FOR ENGINE OIL LEAKAGE