Camshaft Position Sensor: Inspection
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT CAMSHAFT POSITION SENSOR
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
TEMPERATURE SPECIFIED CONDITION CHARTTemperature Specified Condition Cold 1,630 to 2,740 Ω Hot 2,065 to 3,225 Ω HINT:
In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).
If the resistance is not as specified, replace the camshaft position sensor.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the resistance.