Accelerator Pedal: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Avoid any physical shock to the accelerator pedal.
Do not disassemble the accelerator pedal.

INSTALL ACCELERATOR PEDAL ASSEMBLY
1. Install the accelerator pedal with the 2 bolts.
  Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf)
  
  Fig 1: Identifying Accelerator Pedal With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the accelerator pedal connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)