Transmission Revolution Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION REVOLUTION SENSOR
1. Coat a new O-ring with ATF, and install it onto the transmission revolution sensor.
  
  Fig 1: Identifying O-Ring And Transmission Revolution Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission revolution sensor with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 2: Identifying Bolt And Transmission Revolution Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the transmission revolution sensor connector.
INSTALL BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY TRAY
INSTALL BATTERY (See INSTALLATION )